Agree with the Funbeam. My 6 blade fan fit
perfectly with cutting the blades and it clears
the rack by a good 1/2 inch. I took it to a
tool maker who used a reamer to make the
hole 1 inch. The problem is that my Tiger
pump shaft was just a few 1000ths over 1 inch.
The inch hole was too tight. He reamed it out
to 1.005 and it slid right on. Use a reamer not
a drill.
Once I get the radiator out, I'll pull the fan and
look for numbers. Right now two blades are
wrapped back around the pump. I am having
second thoughts about straightening the
blades. Perhaps I'll have it magnafluxed after
I bend the blades back. I'd hate to throw a
blade after I get everything fixed.
Dave Johnson B382002668 (Under repair) Aurora, IL
|