"Daniel S. Eiland" wrote:
> Hi Listers,
>
> ------
> Second question, where can I get the mounting bracket and hardware to
> mount the original 7" brake booster to my car?
> Dan Eiland
> B382002652
> Finally in for paint.
Dan,
If you have the 7" booster already, you will notice some threaded holes on the
side of the hydraulics. A simple "L" bracket is used to fasten to the flat
welded
brace between the firewall and the fender (NOT the round bolted brace), but
short
and about 8" below the fender line.
A 5" booster uses a right angle bracket that takes two of the hydraulic unit
bolt
locations and one bolt to the brace. The 7" must have the bracket bent at
about a
45 degree angle. It is a really tight fit. I found the "banjo" fitting is NOT
compatible with this installation, from a room problem, and the bent tube shown
on
some of the Mk II pictures will allow vacuum connection without hassle.
Steve
--
Steve Laifman < Find out what is most >
B9472289 < important in your life >
< and don't let it get away!>
_/_/_/_/_/_/_/
_/ _/_/_/ _/_/_/ _/
_/ _/ _/ _/ _/ _/ _/_/_/_/
_/ _/ _/ _/ _/ _/ _/
_/_/_/_/_/__/_/_/_/_/_/_/_/_/_/_/_/_/_/_/_/_/_/
_/
_/_/_/
|