larry rominger wrote:
>I set about replacing the pinion seal on the Tiger
>today. Everything went well untill I tried to remove
>the pinion flange. It would not budge despite attaching
>a three-legged puller of substantiol size, some tapping,
>and a slight application of heat. I have never done one
>of these before so the tapping and application of heat
>was done with considerable caution.
Mine came off easy, so I cannot offer advice, except: might it
help to dribble some penetrating oil into the connection between pinion
shaft and flange, from the back?
Lawrence R. Wright, Purchasing Analyst
U S Office Products, Mid-Atlantic District
Formerly Andrews Office Products
larry.wright@usop.com (new)
Ph. 301.386.7923 Fx. 301.386.5333
|