tigers
[Top] [All Lists]

Re: inquiry 092299a

To: "Wright, Larry" <larry.wright@usop.com>,
Subject: Re: inquiry 092299a
From: "Doug Mallory" <rdmallory@earthling.net>
Date: Thu, 23 Sep 1999 09:11:11 -0400
JEEP
Also used the shims in the early models..
Doug
-----Original Message-----
From: Wright, Larry <larry.wright@usop.com>
To: National Corporation (E-mail) <tigers@autox.team.net>
Date: Thursday, September 23, 1999 2:18 AM
Subject: inquiry 092299a


>I wrote:
>>How the heck am I supposed to arrive at 6 to 8 of 
>>end play with those materials? Why not demand 
>>clearances in microns? And, so far, I have not heard 
>>of a source for the shims. Betcha making them would 
>>take forever. Oh, yes, with the one-axle pushing against 
>>the other, doesn't end play at one end affect the other?
>> BTW, this is with no gasket back there whatsoever. 
>>I'm planning on using Permatex in a thin film. But: where? 
>>It seems like every two pieces in the "stack" would need 
>>a gasket or Permatex, and that could really add up. Am 
>>I wrong? They only used one gasket per side originally, 
>>right? If so, where and why?
>
>Actually, I _am_ making the shims, and making headway. If anyone has
>been inside one of these before, and confirm that the end float on each
>side is interdependent, please e-mail me. Also, I'm really curious about
>gasket location/quantity; my plan still calls for Permatexing
>everything, but I'm guessing 3 to 4 layers per side, this could affect
>end play as well. Thoughts?
>
>Lawrence R. Wright, Purchasing Analyst
>U S Office Products, Mid-Atlantic Division
>Formerly Andrews Office Products
>larry.wright@usop.com (new)
>Ph. 301.386.7923  Fx. 301.386.5333
>
>


<Prev in Thread] Current Thread [Next in Thread>