In a message dated 3/30/99 11:09:58 PM Eastern Standard Time, mjsutter@cts.com
writes:
<<
I have a Canton Billet Oil Filter Adapter installed on my car. You can view
this part at www.mustangsplus.com.index.htm. Go to the parts department and
look it up under oil pans. Its a nice part. The block portion is black
anodized aluminum and the mounting bolt is cad plated. I also installed a
remote oil filter mount, oil cooler and braided lines from Earls Supply,
The Earls mounting block is also a real nice billet part, and it was
cheaper than those crappy cast mounting blocks you see at the corner auto
parts store. I run CAT 1 5/8" headers, and have no fit problems and no oil
leaks. The block adapter resides within 3/8" of the #5 primary tube but I
can still remove the block adapter without any problems. I fought with a
lot of oil leaks from the stock oil filter adapter configuration for about
six months before I scrapped it and went with my present set-up. I am not
familiar with the Sunbeam Specialties headers you're using, so this info
may not be of any use. Thats my two cents.
Mike
>> Mike, Where in the engine bay do you mount your remote filter?
Thanks,
Paul
|