Jim,
Assuming you already have a close-ratio toploader, you might consider
having it gone through (rebuilt) with wide ratio gears. There have been
postings of recommended places to have this work done if you don't want to
do it yourself. It might seem an intimidating job, but I did mine, so how
hard can it be? With new synchros, detents, seals, bearings, etc., you'll
have yourself a sweet shifting unit and no external changes.
Bob
At 12:22 PM 3/30/99 -0600, James E. Pickard wrote:
>Anybody know where I can get a wide ratio toploader? I assume they are
>not all the same (that would be too easy). Which ones (if any) will fit
>my Mark I without modification?
>
>Jim Pickard
>B9473298
Robert L. Palmer
Dept. of AMES, Univ. of Calif., San Diego
rpalmer@ames.ucsd.edu
rpalmer@cts.com
|