ok i looked in the workshop manual,section E page 2 fig 1
nice pic of the trans. so the bearing is held in with the plate that
slides over the input shaft,with the 4 bolts in it?
when i mated my top loader to my 6 bolt housing ( dale mod), i just
bolted them together. i haven't run the car yet but everthing fit, i
think?
i used the stock clutch fork with a stock t.o. bearing. i had to change
the pivot plate that is riveted to the bell housing that the fork rocks
on.
i hope i don't have to pull it all out to fix somthing.
scott
B9472628
|