Lawrence R. Wright
Purchasing Analyst
Andrews Office Products Div. of USOP
lrw@aop.com
Ph. 301.386.7923 Fx. 301.386.5333
* -----Original Message-----
* From: Steve Laifman [mailto:laifman@flash.net]
* "Wright, Larry" wrote:
* > Spell-checker whimsy: the suggested replacement to "balljoint"
* > is "balloonist"!
* Larry,
* Sounds about Wright to me {9->. A "ball joint" is a (SNIP)
'balloonist' is (SNIP)
* Seems close enough for Government Work. Maybe your spell checker
isn't so
* dumb, after all.
OK, that means:
- To remove the balloonist, strike with two hammers from opposite sides
simultaneously.
- The balloonist should be copper plated to reduce corrosion.
- Make sure the balloonist is oversized for a tight fit.
- Remember to insert a grease fitting into the bottom of the balloonist.
|