Lawrence R. Wright
Purchasing Analyst
Andrews Office Products Div. of USOP
lrw@aop.com
Ph. 301.386.7923 Fx. 301.386.5333
Doug Mallory wrote:
* Subject: Re: inquiry 012999a
* There is not much to the plate. It is a bear to get to
* though. You have to remove
* the panel next to the wheel hump and fish it out after
* bending up the tabs. If you drop it it's gone.
Thanks for that tip; cannot imagine anyone wanting anything rattling
around in the sills forever. Perhaps threading a bread tie or other
piece of wire through one of the holes in the plate as a "safety
harness" is a _really_ good idea. If nobody steps forward with a donor
plate, mebbe I'll try a longer bolt to allow a nut on the backside.
|