>Date: Tue, 29 Sep 1998 12:51:32 +0100
>To: Theo Smit <TSmit@novatel.ca>
>From: ritchie@mcn.org (Armand & Lorie Ritchie)
>Subject: RE: tonneau
>Cc:
>Bcc:
>X-Attachments:
>
>>I have an original (real old, anyway) series V tonneau cover that is shorter
>>than what would be required to stretch to the defrogger vents. If yours is the
>>same length then I'm guessing that it won't fit.
>>
>>One of the PO's of my Tiger re-skinned the dash and did not reinstall the
>>lift-a-dot studs on the dash (mine's a mk1A), as well as filling in the
>>holes in
>>the doors (thanks, buddy). So sometime this winter I have to the
>>poke-the-pin-from-under-the-dash thing to figure out where they went. I have
>>some Alpine V doors that I will measure to figure out where the door studs go.
>>
>>Regards,
>>
>>Theo Smit
>>tsmit@novatel.ca
>>B382002705
>>
>>
>Theo, thanks for the reply. On my tiger the studs go on the front corners
>of the demister bezels. Two on each bezel, and there's only one snap on
>each door, no studs on the doors. hope this helps thanks again armand
>
ritchie@mcn.org
Armand & Lorie Ritchie
|