Everyone;
When I took the crossmember off my current project there were NO shims. I
did not realize something was missing until I took of the crossmember of my
second project--lo and behold--shims! Very corroded and useless. I read an
e-mail in the last day or so (must have deleted it-duh) need to find a
source for them or a drawing in order to make a pair or two. Thanks. Lou
----------
> From: Gary A Winblad <gary_winblad@juno.com>
> To: FrizBMG@aol.com
> Cc: tigers@autox.team.net
> Subject: Re: Odds and Ends- Engine critique
> Date: Sunday, August 09, 1998 12:20 AM
>
>
> On Sun, 9 Aug 1998 00:03:35 EDT FrizBMG@aol.com writes:
> > Hi Tigers
>
> Tony
>
> >PS.Do the front end shims(the aluminum spacers)between the crossmember
> >and the
> >frame get installed large side facing front?
>
> NO, the large (thick) side is in the back. And they should be riveted to
> the
> crossmember so you don't have to tape them in place.. think it takes two
> large pop-rivets on each side.
> Gary
>
|