| To: | "Tigerlist *" <tigers@Autox.Team.Net> |
|---|---|
| Subject: | Tight Fit |
| From: | "Larry Wright" <lrw@aop.com> |
| Date: | Tue, 26 May 1998 08:08:50 -0400 |
Steve Laifman wrote: >Anyway, The "friction" fit (or intereference fit) is a standard industrial ((SNIP)) >Problem is that after many, or poor, rebuilding this interference gets less as the >shaft wears, and/or the hub wears. No opportunity to drill and tap the pulley for a setscrew? Lawrence R. Wright Purchasing Analyst Andrews Office Products, Divison of USOP PH 301-386-7923 FX 301-386-5333 lrw@aop.com |
| <Prev in Thread] | Current Thread | [Next in Thread> |
|---|---|---|
| ||
| Previous by Date: | Re: Rochester Carb, Steve Laifman |
|---|---|
| Next by Date: | Hardtop? Convertible? You decide., Larry Wright |
| Previous by Thread: | Re: Tight Fit, Steve Laifman |
| Next by Thread: | Re: Hardtop? Convertible? You decide., Steve Laifman |
| Indexes: | [Date] [Thread] [Top] [All Lists] |