John,
the stud arrangement is 4 x 4 1/4 PCD (pitch circle diameter). This
means that if you drew a circle form the centre of the hub to locate the
studs, the diameter iof that circle is 4 1/4 inches or the metric
equivalent (108 mm?). The 4 studs are located on two lines fron the
centre at 90 degrees to each other.
Its the same pattern as most European 4 stud Fords.
regards
Jeff
In message <348228EE.DCB@gte.net>, john brawley <johnj7@gte.net> writes
>Can anyone tell the the bolt pattern size for the Tiger in
>mm and inches? Is it 4 X 108mm or 4 X 4.25 inches?
>
> Thanks, John
--
Jeff Howarth
|