On Sat, 15 Nov 1997, Anita Barrett <anitabrt@mindspring.com> wrote:
>Tigers,
> I am about to start the replacement of most of the lower 1/4 of the
>Tiger sheet metal along both sides. I have done this before on other
>cars using 24 gauge steel sheet metal and also using galvinezed sheet
>metal. This time I aquired a 4ft.X 10ft. 24 gauge Stainless Steel # 304
>sheet.
>I do have a MIG with SS wire and argon. Any words of wisdom from
>the list?
>
>(Sorry about the " marks, should have been ft.)
>Jim Barrett Tiger II 351C and others
>
>
>
|