In a message dated 97-09-09 02:49:57 EDT, anitabrt@mindspring.com (Anita
Barrett) writes:
<< out of my eye as a result. ( This was with safty glasses and goggles
too.)
I drilled the steam holes in the block to match the 351W head gaskets
as was recommended at that time. I used the original 289 head bolts with no
problem.
I di >>
Do these 'steam' holes correspond with the lozenge shaped holes on the intake
side of the head? Are they the equivalent of the small hole just over the
bore in the 289-302 block?
Ray
|