Looking for advice on installing recently recieved rear window stainless
trim with new clips from Sunbeam Specialties. Obviously the edge of the
two sides goes under the cut in the rubber. I can manage this part, but
it does seem to want to "poke out" on top edge when bottom edge is
seate, and vice-versa. Got instructions from Rick on the clips using a
wedge on the outside edge and putting hardening material glob (epoxy) in
the back of the outside edge.
Can't seem to get it all together, with the clip under the rubber lip,
top and bottom.
Must be enough experience out there to do this smart, and not loose the
expensive pieces at speed on the Freeway.
BTW: Anyone got specifics on adding a screw to the clip-on headlight
rims so THEY don't come off on the Freeway?
Steve
--
Steve Laifman < Find out what is most >
B9472289 < important in your life >
< and don't let it get away!>
_/_/_/_/_/_/_/
_/ _/_/_/ _/_/_/ _/
_/ _/ _/ _/ _/ _/ _/_/_/_/
_/ _/ _/ _/ _/ _/ _/
_/_/_/_/_/__/_/_/_/_/_/_/_/_/_/_/_/_/_/_/_/_/_/
_/
_/_/_/
|