Another option Mike, is to contact Mark Williams Ent. in Louisville, CO. They
make 2 piece spridget racing axles, if you gave them the length and diameter
along with the bolt pattern from the Singer, I'd bet they could make you a pair
of axles with the correct outer flange. They'd 'only' have to recut the length
and make a 'special' flange end for you.
Just another way to skin the cat....
Mark Haynes
It only goes one way-Pay it Forward
From: Mike Rambour <lists@dinospider.com>
To: Spridgets <spridgets@autox.team.net>
Subject: [Spridgets] Spridget rear axle
____________________________________________________________
No Branches = Great Rates
High Yield CDs & Savings Accounts. 24/7 helpful customer service.
http://thirdpartyoffers.netzero.net/TGL3231/55fc0da3c342bda37709st01duc
------------------------
spridgets@autox.team.net
Archive: http://www.team.net/archive
|