This is not a direct answer to your question but if you go to page 123 of this
pdf you can at least see a factory illustration of the brackets.
http://www.spridgetguru.com/TchIndx17_files/AKD3513.pdf
jay
________________________________
From: Tim Collins <thcollin@mtu.edu>
To: spridgets@autox.team.net
Sent: Mon, December 17, 2012 1:03:55 PM
Subject: [Spridgets] Heat shield braces
I'm trying to determine where the rear (firewall side) brace to the carb heat
shield fastens to the engine or transmission. I've got the front one OK, but I
need to fabricate the rear brace so . . . where does it attach to the engine or
wherever?
Thanks
------------------------
spridgets@autox.team.net
Archive: http://www.team.net/archive
|