spridgets
[Top] [All Lists]

Re: [Spridgets] Throw-out bearing

To: "spridgets@autox.team.net" <spridgets@autox.team.net>
Subject: Re: [Spridgets] Throw-out bearing
From: Rick Fisk <refisk@chartermi.net>
Date: Mon, 28 Nov 2011 23:50:51 -0500
Peter May Engineering in the UK has roller bearing kits.  Kinda pricey, 53.50
Euros, but look to be very high quality.  They also have a hydraulic throwout
bearing kit.  Hmmm.....

Rick

Sent from my keyboard

On Nov 28, 2011, at 9:52 PM, Gerard <pixelsmith@gerardsgarage.com> wrote:

> There are some out there, but the problem with a roller bearing on the stock
fork is that with a pivoting fork, The TO  bearing is only concentric to the
1st motion shaft/pressure plate at one point in the arc, (theoretically, if
you are lucky). The right way to do it would be by eliminating the fork
entirely, and using an internal, concentric slave cylinder. Either that or
redesign the front cover and fork to function like the Datsun setup. I'd
consider making it, but I'm sure no one would be willing to buy them.
>
> Gerard
_______________________________________________

Donate: http://www.team.net/donate.html
Suggested annual donation  $12.75
Archive: http://www.team.net/archive
Forums: http://www.team.net/forums

<Prev in Thread] Current Thread [Next in Thread>