| To: | Spridgets@autox.team.net |
|---|---|
| Subject: | [Spridgets] engine bearings |
| From: | Edward Perez <eap2140@yahoo.com> |
| Date: | Fri, 5 Jun 2009 14:14:39 -0700 (PDT) |
I'm in the process of ordering parts for rebuilding my engine and I have a question. I'm planning on going .020 over. Moss has a different part # for the rod bearings for .020 than stock. Is there something I will have to do to my crankshaft to accommodate these? I have a 1275. _______________________________________________ Support Team.Net http://www.team.net/donate.html http://www.team.net/archive http://autox.team.net/mailman/listinfo/spridgets |
| <Prev in Thread] | Current Thread | [Next in Thread> |
|---|---|---|
| ||
| Previous by Date: | Re: [Spridgets] Incredible, Glen Byrns |
|---|---|
| Next by Date: | Re: [Spridgets] here I go again ..., Frank |
| Previous by Thread: | [Spridgets] Dr. Bob update, Ron Soave |
| Next by Thread: | Re: [Spridgets] engine bearings, Billy Zoom |
| Indexes: | [Date] [Thread] [Top] [All Lists] |