There is one more issue.
The center hole is not large enough.
You have to either enlarge the center hole or run 1/4"
spacer plates between the rims and the hub.
At least this was the case with the steel Vega wheels
I once had.
They did not look too bad. I always thought a little moon
hubcap on them would look good. But I never found anything
that would fit.
----- Original Message -----
From: "David Lieb"Subject: Re: [Spridgets] Morris truck photos
>> Does this mean all Vega wheels fit the Spridgets too?
>
> Lin,
> Yes, Chevy Vega (and Monza) wheels are some of the few that share the
> 4-on-4" bolt pattern of the Spridget. Vega GT wheels are especially nice for
> autocrossing as they are 6" wide. OTOH, If you choose to run Vega wheels, do
> NOT use the stock (11/16" socket) Spridget lugnuts as these will tear right
> through the holes. The after-market lugnuts for Minitors (13/16" socket)
> work well.
> David
_______________________________________________
Support Team.Net http://www.team.net/donate.html
http://www.team.net/archive
http://autox.team.net/mailman/listinfo/spridgets
|