spridgets
[Top] [All Lists]

Re: [Spridgets] Now it starts

To: Frank Clarici <spritenut@comcast.net>
Subject: Re: [Spridgets] Now it starts
From: Linda Grunthaner <grunthaner@gmail.com>
Date: Fri, 30 Jan 2009 09:26:05 -0500
Congratulations good work.
Lin

On Thu, Jan 29, 2009 at 6:10 PM, Frank Clarici <spritenut@comcast.net>wrote:

> And runs well.
> Turned out to be the header was keeping the bottom of the intake from
> sealing.
> In pulling it off to check to see if I pulled out all the paper towels
> keeping dirt out of the engine...
> I knew I pulled them out but did I forget one?
> Turns out, no, I didn't leave any towels in the holes. But Brian noticed
> that there was a paint mark on one hole of the gasket but not the other.
> Turns out the intake was rocking on the center header pipe, not so much the
> intake but the heat shield.
> Some strategic blows with a BFH fixed it right up. It ran long enough to
> set the carbs, now it runs well.
> I knew it was acting like a major intake leak but the nuts were tight, the
> manifold was not damaged, who would have thunk it?
>
> --
> Frank Clarici
> Toms River, NJ
> _______________________________________________
> Support Team.Net  http://www.team.net/donate.html
>
> You are subscribed as grunthaner@gmail.com
>
> http://www.team.net/archive
>
> http://autox.team.net/mailman/listinfo/spridgets
_______________________________________________
Support Team.Net  http://www.team.net/donate.html


http://www.team.net/archive

http://autox.team.net/mailman/listinfo/spridgets

<Prev in Thread] Current Thread [Next in Thread>