Excellent idea!
I take it that this piece of metal cannot touch the rear housing?
Chris
-----Original Message-----
From: Frank Clarici [mailto:spritenut@comcast.net]
Sent: Wednesday, September 10, 2008 9:54 PM
To: Chris Manuel
Cc: spridgets@autox.team.net
Subject: Re: [Spridgets] A Ha! think I found the tach problem
Chris Manuel wrote:
> But I am missing the metal band that surrounds the "loop" assembly on the
> back. Is there a replacement part out there for this or a good way to
> fabricate one?
>
>
>
After a couple of tries, I managed to make one using some hobby brass
off the rack at the local hardware store.
It's just two 90* bends and some work with a file, it was trying to
drill the hole in the middle that was the tough part.
Try and hold that tiny piece on a block of wood and drill it.
I did get it drilled using a vice but I remember make a few of them
before I got it right.
If I recall, I used a 1/4" wide thin strip of brass, it comes a foot
long do you get plenty of tries for a couple of bucks.
--
Frank Clarici
Toms River, NJ
_______________________________________________
Support Team.Net http://www.team.net/donate.html
http://www.team.net/archive
http://autox.team.net/mailman/listinfo/spridgets
|