In my experience, don't email McGregor, call. Then keep calling until
they pick up. After that it's all golden..
Lester
On Aug 10, 2008, at 5:19 PM, Bill L wrote:
> Hello Spridgets,
>
>
> anyone have any idea as to the size of the screws that hold
> the front clips onto a hard top?... 8/32s fit into the holes, but a
> little sloppy, .. i haven't tried 10/32s (non on hand), but can get
> some tomorrow.. or are they some weird british size that has a "B" in
> it?..
>
> also.. macgregor is completely unresponsive to inquiries. any
> suggestions on obtaining the rear rubber seal (this is a factory '66
> top with the channel around the back to hold in the rubber.
> --
> Best regards,
> Bill L. mailto:pythias@pacifier.com
>
> '66 Sprite MKIII HAN8L49403 "the red thing"
_______________________________________________
Support Team.Net http://www.team.net/donate.html
http://www.team.net/archive
http://autox.team.net/mailman/listinfo/spridgets
|