Oooh, ooooh.... I do, I do..
948 1/2" from center of peg to face of carbon
1098 3/4"
1275 .970"
Peter C.
===
At 01:56 PM 8/5/2008, Weslake1330@aol.com wrote:
>So, does anyone know what the difference is between the 948/1098 bearing and
>the 1275 bearing?
>
>In a message dated 05/08/2008 19:15:30 GMT Daylight Time, jlaird237@cox.net
>writes:
>
>Tis my opinion, from experence, that some clutch sets are improper, ie the
>throw out bearing is thiner by 1/4 inch than it should be. Some others have
>something else wrong with them that I don't understand. I have had both
>problems.
_______________________________________________
Support Team.Net http://www.team.net/donate.html
http://www.team.net/archive
http://autox.team.net/mailman/listinfo/spridgets
|