Bill
I measure 26TPI Definitely NOT 1.0mm pitch. The od of the threads is .2752"
or 6.991mm. My hole guage says 9/16". Since I don't have a thread mic I
can't say exactly! Hmmm, maybe I need to order one....
Hal
-----Original Message-----
From: spridgets-bounces+hal=katemuir.com@autox.team.net
[mailto:spridgets-bounces+hal=katemuir.com@autox.team.net]On Behalf Of
Bill L
Sent: Tuesday, June 03, 2008 8:38 PM
To: spridgets@autox.team.net
Subject: [Spridgets] tappet threads?
Hello Spridgets,
anyone out there know offhand what the threads/inch of the tappet
adjusters?....i've been assuming they are 14/28, .. National Fine
Thread...
--
Best regards,
Bill mailto:pythias@pacifier.com
'66 Sprite HAN8L49403
"I tried to think but nothing happened!" - Curly
_______________________________________________
Support Team.Net http://www.team.net/donate.html
http://www.team.net/archive
http://autox.team.net/mailman/listinfo/spridgets
|