The door hinge screws are actually oizi-drive and not Phillips so hard to
find here in the US.
If you are not worried about being totally original you can get Phillips
ones here www.mcmaster.com
Thanks
Duncan
-----Original Message-----
From: spridgets-bounces+duncan=pondhop.com@autox.team.net
[mailto:spridgets-bounces+duncan=pondhop.com@autox.team.net] On Behalf Of
lindalnhvt@nhvt.net
Sent: Tuesday, April 22, 2008 8:23 PM
To: spridgets@autox.team.net
Subject: [Spridgets] Carbs and door hinge screws
List
I'm looking for a souce for the door hinge phillips screws that secure the
hinge to the A post. I can find the thread, but only in a hex head bolt.
The buguye doors need a phillips screw.
Next --- Where do I look for step by step directions for adjusting the
carbs. I got the 66 out of storage yesterday and after some effort, got it
started and it ran pretty well on the 15 minute ride home. I took it out
again last night when the engine was still warm and it started right away,
with a bit of sputtering, but not too much. I tried to start it this
morning when it was 37 degrees and again tonight when it was 55 degrees,
but it won't catch, or even start to catch, when I turn it over. Air
filters are off, pistons move freely and it smells like it's getting fuel.
I need help to get it running and to stay running.
Thanks
Dick B. in NH
You are subscribed as duncan@pondhop.com
http://www.team.net/archive
http://autox.team.net/mailman/listinfo/spridgets
--
No virus found in this incoming message.
Checked by AVG.
Version: 7.5.524 / Virus Database: 269.23.3/1391 - Release Date: 4/22/2008
8:15 AM
_______________________________________________
Support Team.Net http://www.team.net/donate.html
http://www.team.net/archive
http://autox.team.net/mailman/listinfo/spridgets
|