Hello everyone,
My midget mkIII fuel gauge reads half all the time when the ignition is
on. I've seen many posts talking of a full gauge when tank is empty and
vice-versa, but never seen 'half all the time when there's current getting
to the gauge'.
Any idea? Could it be a bad earth somewhere or is it possible that the
sending unit is blocked halfway?
Thanks in advance,
Max
> Hey Biff,
>
> Why do you call your black Mk II Sprite gray? Just curious.
>
> Mike C
>
> -----Original Message-----
>>From: Biff Jones <biffjones@verizon.net>
>>Sent: Apr 22, 2008 10:41 AM
>>To: spridgets@autox.team.net
>>Subject: Re: [Spridgets] BE Fuel Sending unit
>>
>>The bugeye sending unit has the following resistance readings:
>>0 Ohms = open circuit (broken wire)
>>14 Ohms = Full (up position)
>>90 Ohms = Half tank
>>258 Ohms = Empty
>>
>>These are for sending unit # FT5300/32 and gauge unit # FG2530/31or
>>FG2530/64
>>
>>Latter sending units read the opposite of above, i.e., Full = 120 Ohms,
>>Empty = 30 Ohms
>>
>>Cork gasket should work fine without any goo.
>>
>>Biff Jones
>>'Frogarri' '59 Bugeye
>>'Ole Gray' '61 AH Sprite
>>http://sprites2.homestead.com/
>>_______________________________________________
>
>
> ________________________________________
> PeoplePC Online
> A better way to Internet
> http://www.peoplepc.com
> _______________________________________________
> Support Team.Net http://www.team.net/donate.html
>
> You are subscribed as max@maxengland.com
>
> http://www.team.net/archive
>
> http://autox.team.net/mailman/listinfo/spridgets
_______________________________________________
Support Team.Net http://www.team.net/donate.html
http://www.team.net/archive
http://autox.team.net/mailman/listinfo/spridgets
|