At the buster cluster I learned (from Frank, et al) that an appropriately
sized hose clamp will do quite nicely to hold the headlight/ignition switch
in position. Not concours, but readily available and more effective than
the official little wire clip.
Hal
-----Original Message-----
From: spridgets-bounces+hal=katemuir.com@autox.team.net
[mailto:spridgets-bounces+hal=katemuir.com@autox.team.net]On Behalf Of
Mike/Donna Carpenter
Sent: Tuesday, February 19, 2008 11:34 AM
To: vern@srvinet.com; Spridgets@autox.team.net
Subject: Re: [Spridgets] Bugeye ignition sw.
The Bugeye switch does rely on a wire clip and it works very well. I do not
know where you would buy one but that is what you need.
Mike C
-----Original Message-----
>From: "vern@srvinet.com" <vern@srvinet.com>
>Sent: Feb 19, 2008 2:02 PM
>To: Spridgets@autox.team.net
>Subject: [Spridgets] Bugeye ignition sw.
>
>My bugeye came comepletely disassembled and I can't see
>what holds the ignitions sw. in the dash. In mosses catalogue
>there looks to bed some kind of wire clip or something, but it
>doesn't look like it would hold anything. Hate to rely
>on glues. :-)
>Vern
>
>--
>See my
>59 bugeye
>78 MGB
>79 midget RB at:
_______________________________________________
Support Team.Net http://www.team.net/donate.html
http://www.team.net/archive
http://autox.team.net/mailman/listinfo/spridgets
|