Your putting a 125 in a 79? The 79 slave was on the other side of
the engine and used a red plastic hose. running down in front of the pedal box.
A 1275 would have a 1/4 line traveling across in front of the battery
and down to a welded tab on the inner fender, then fitting a rubber
hose to the slave. A 1098 and 948 used a steel line from master to
slave directly no bracket.
I hope I understood your question.
Peter C
==
At 09:04 AM 11/26/2007, you wrote:
>I have looked all over and can't find where the hose from the clutch slave
>cylinder fastens to the body. I can make a fitting, but am wondering
>what is correct. I am putting a 1275 engine in, but from all the books
>can't see where this should change the attach point for the slave hose.
>Vern
>
>--
>See my 79 midget RB at:
>
>http://olsen.ispeedwireless.net/
>_______________________________________________
_______________________________________________
Edit your replies
http://www.team.net/archive
http://autox.team.net/mailman/listinfo/spridgets
|