Hi Jim,
If you're after concourse, this won't be OK, but if function is in order try
this. You can use 1/8" copper tubing. You will need to make a 3 or 4 turn
spiral near the block. Wrap it around around a screwdriver handle or a
section of broomstick to get the flexibility needed to avoid a fatigue
crack/break. Then use a compression nut and ferrule on each end. Block
and gauge.
I used it that way for a couple hundred K miles on my old 1275 without a
problem.
The nylon tubing will hold that pressure for a short period of time, but
heat is an enemy of nylon and makes it prone to failure, Usually at the
most inopportune times!! Like when you're driving to a show!!
Paul A
----- Original Message -----
From: "James E. Pickard" <geowiz.sgy@cox.net>
To: "Spridgets e-mail list" <spridgets@autox.team.net>
Sent: Thursday, November 01, 2007 8:06 PM
Subject: [Spridgets] Leaky oil pressure hose
> I received my nicely rebuilt oil pressure/temperature gauge from Mo-Ma and
> installed it in the car, only to find the old rubber hose that connects
the
> two pieces of metal tubing for the oil pressure is cracked and leaking. I
> need the car operational Saturday morning, so there isn't time to order a
new
> part. My previous attempts to find a 1/8" OD hose that can take 80 psi at
a
> local hardware store and AutoZone were fruitless. Suggestions? How much
> pressure can clear plastic tubing stand?
>
> Jim Pickard
> B9473298 ('65 Tiger)
> AN5L/12109 ('59 Sprite)
> 2003 Mini Cooper
> Lafayette, LA
> _______________________________________________
> pasgeirsson@worldnet.att.net
>
> Edit your replies
>
> http://www.team.net/archive
>
> http://autox.team.net/mailman/listinfo/spridgets
_______________________________________________
Edit your replies
http://www.team.net/archive
http://autox.team.net/mailman/listinfo/spridgets
|