Got that sucker now, had to take another 1/16 inch or so off of each or the
oil pump ears. I would guess that the factory that made the backing plates did
not get the can exactly centered.
So much for quality control, however it did fit with the orginal oil pump so
guess I best shut up.
I have two, one unmodified and one where the edges of the case where the
bolts
go through are cut down. Both are same brand both are new.
There is no way that pump will fit under the backing plate I have. The pump
is
just too large for the cut out where the tin can is soddered on.
What the heck, am I stupid or something in my old age. This is not rocket
science.
Anyone else put a new 948 pump in lately and where did you get it. OR OR OR
do
I have a backing plate from something else????? the tranny bolts up to it ok.
_______________________________________________
Edit your replies
http://www.team.net/archive
http://autox.team.net/mailman/listinfo/spridgets
|