Derf:
Thanks. I think if it were A-arm bushings, it would not go away when I
tighten up the bearing. One "castle" is really quite a lot in
thousandths of an inch, I believe. Although I'm no machinist, so numbers
like that don't translate very well into "feel" for me.
The fine adjustment is done with shims but I don't know where to get
them or where to put them.
JohnD
-----Original Message-----
From: derf [mailto:derf247@gmail.com]
Sent: Monday, October 01, 2007 3:05 PM
To: Deikis, John G
Cc: spridgets@autox.team.net
Subject: Re: [Spridgets] Tapered roller bearings
First, try switching the nuts. You may find one works better on the
other side.
Then, I wouldn't fool around with shims. Just set it a little loose
or tight and go with it. I would lean toward the tight side. As long
as it turns freely and has no end play, it should be good.
Third option is to replace the bearings and see what kind of
adjustment you come up with.
Have you inspected everything? One notch from binding to too much end
play seems too drastic to me. Are you sure the 12-6 rocking play you
are feeling is the spindle bearings? More likely the A-arm bushings
or lower pin are getting worn.
Cheers,
Derf
_______________________________________________
Edit your replies
http://www.team.net/archive
http://autox.team.net/mailman/listinfo/spridgets
|