Greetings,
I probably should have asked this much earlier....but oh well..
My 1275, now has a belt drive cam...and thus no crankcase breather on the
timing cover.. and of course no side covers and no breather there.
There is however, a breather on the valve cover.
Considering that the 1098 sucks air out of the crankcase, just above the
lifters, and the pushrod holes are quite open.. I figure I should be able to
vent the engine sufficiently via the breather on the rocker cover.. but i may
want to widen the tiny hole (~2mm - 3mm now) in the breather pipe.
Has anyone done this and found it to be succesful or otherwise?
Cheers
Andy
(should be at All-British Display right now...but..."needs must, when the
Devil vomits into your kettle".....or jams your ribcase in first... whichever
the case may be.)
---------------------------------
Sick of deleting your inbox? Yahoo!7 Mail has free unlimited storage. Get it
now.
_______________________________________________
Edit your replies
http://www.team.net/archive
http://autox.team.net/mailman/listinfo/spridgets
|