Toolbox creep tip: Scratch the drift off your list, and get a small
metal lathe instead... Then you can make a drift any size ya want!
Oh, and I have used a wooden dowel for that same purpose....
Marc
Daniel1312@aol.com wrote:
> Hi List,
>
> I checked my drill box (not the cobalt bit set) and found I did have a half
> inch bit and using the grease trick and a lump of wood on the drill bit the
> spigot bearining is now out.
>
> I've added a half inch drift to my 'tools I want to buy' list.
>
> Thanks
>
> Daniel1312
_______________________________________________
Edit your replies
http://www.team.net/archive
http://autox.team.net/mailman/listinfo/spridgets
|