I just measured one of my ribcases -- 1/2" on the input shaft.
Larry Daniels
----- Original Message -----
From: "WJHS1960" <WJHS1960@comcast.net>
To: <spridgets@autox.team.net>
Sent: Wednesday, September 05, 2007 5:49 PM
Subject: Re: [Spridgets] Crankshaft Spigot bearing removal
<<But wouldn't it be the same as the I.D. of the
aforementioned bearing?>>
Yes Pat, BUT most "shadetree mechanic" situtions do not allow for having a
caliper for measuring something THAT small (5/8" and smaller). BUT that
said
a drift should be the same size as the rib-caged tranny input shaft which
Daniel says he does not have.
So the answer he is looking for would be a drift either 11/16s or 5/8s" or
9/16s or 1/2s", I beleive.
I also do not have an input shaft to measure. Perhaps someone DOES have
either or both handy to measure correctly?!?!?
_______________________________________________
Edit your replies
http://www.team.net/archive
http://autox.team.net/mailman/listinfo/spridgets
|