OOOOPs,
IIRC the ones on FROG AYE are 1 7/8, Which I could only locate in 3/4
drive, so had to purchase both the socket and an adapter....
I will rummage around the garage in the a.m to see if I can locate mine and
confirm the size.
Hal
-----Original Message-----
From: spridgets-bounces@autox.team.net
[mailto:spridgets-bounces@autox.team.net]On Behalf Of derf
Sent: Sunday, June 24, 2007 9:15 AM
To: Marc
Cc: Spridgets
Subject: Re: [Spridgets] Hub nut size?
You can use a pair of channel lock pliers to get the nut off. The trick is
to put the channel in the pliers over one of the studs. You only get a
small arc of movement, but it is enough to loosen the nut. You can also
loosen it with a hammer and drift. Don't forget to bend the tab washer
back.
DISCLAIMER: I know that pliers aren't the best tool for this job. BUT,
finding and buying a 1-5/16(IIRC) socket isn't easy or cheap.
_______________________________________________
Edit your replies
http://www.team.net/archive
http://autox.team.net/mailman/listinfo/spridgets
|