Thanks-
I think I'll wait a couple of moon phases. I wanted to dry fit it just to
make sure I had all the parts, but I'll wait until I get some gaskets in.
It appears I am missing a key and a welch plug so far on the remote shaft.
Are these "universal" parts, or do I have to dig deeper and more
specialized?
Since I have this apart, are there any other pieces I should renew?
I still wonder why it was separated, I pulled the gearbox cover and
fortunately things look clean and not glittery or hacked up.
Chris
-----Original Message-----
From: Frank Clarici [mailto:spritenut@comcast.net]
Sent: Monday, June 18, 2007 8:54 PM
To: Chris Manuel
Cc: 'Spridget Mailing List'
Subject: Re: [Spridgets] Rib Case Gear box question
Chris Manuel wrote:
> Hi-
>
> I'm attempting to reassemble the remote control assembly back to the
> gearbox, and I just can't seem to get the shaft to mesh up with the forks
> properly.
This is a twist and hope type of assembly.
If you step away for a bit and come back to it, it just drops in like
the book says. I have done it several times, and it always makes me
wonder. It just does not go no matter what, then after a break, it falls
into place.
But you do have to have all the forks in the neutral (lined up) position
and just twist and wiggle.
--
Frank Clarici
Toms River, NJ
_______________________________________________
Edit your replies
http://www.team.net/archive
http://autox.team.net/mailman/listinfo/spridgets
|