is there an easy way to tell where a dizzy should be getting its vac source
from aside from knowing part numbers? I am building up a 1275 for the BI
from a box of parts and am looking at different manifolds and dizzys. I found
one manifold which fit a 1275 but the carb spacing was closer with different
linkage lengths.Any idea what engine it went on? It was 1&1/4 size. I also
found a dizzy with no provision for a vac advance can. There was no casting on
the side to attach one.At first I thought it might just be a centrifugal only
unit but something else caught my eye.----the plate where the points were
attached was firmly attached to the body of the dizzy. In other words ,it was
a
fixed timing unit. Now, maybe someone was playing around and assembled this
from parts and did not know what he was doing, but then again???? Any
thoughts? It says 24D4 on the side. Bob C in KS
|