Hi Bud,
I was going to use it on a friends golf cart frame. Should I just go with
the MIG and use that on the frame as I was going to get a MIG this year for
body work on my Sprite.
Lin
On 5/1/07, Bud Osbourne <abcoz@hky.com> wrote:
>
> Linda,
> The 110v units are fine for autobody steel, and up to maybe 1/4" can be
> single-pass welded.
> Stay away from the flux core wire. It just doesn't work well on light
> sheet steel, unless there have been some major technological
> break-throughs in the past year or two.
> I'm coming in rather late, on this thread, it sounds like. What were
> you planning to weld, Linda?
>
> Bud Osbourne
>
> -----Original Message-----
> From: owner-spridgets@Autox.Team.Net
> [mailto:owner-spridgets@Autox.Team.Net] On Behalf Of Linda Grunthaner
> Sent: Tuesday, May 01, 2007 9:52 AM
> To: derf
> Cc: Spridget List
> Subject: Re: Horrible Freight Arc Welder question.
>
> Derf & List,
> What gauge steel will this work on?
> Thanks Lin
|