The crankshaft pulley bolt is 1 5/16". Makes it a LOT easier to remove
and replace if you buy an impact socket and use an impact wrench. If you
don't have an air compressor there are electric impact wrenches out there
that will do the job.
-- David Littlefield
On Sun, 27 Aug 2006 13:14:54 -0400 "Phil Nase" <nase@ptd.net> writes:
> Engine is out, clutch removed and the flywheel bolts off. I can't
> budge the
> flywheel loose. What can I do to remove it without boogering
> something up?
>
> Anyone know off hand what size the crank pulley nut is? I have to
> have
> something to hold it when installing the new flywheel and torqueing
> the
> bolts. I have a 1 3/16 socket and its bigger than that.
>
> Phil Nase
|