Thanks to all who responded to my test message. Now that I am able to send
messages here are some results I had with the G-Tech meter. I had tried
posting these before but was not getting through.
> I finally was able to test my Bugeye with the G Tech meter. This is a 948
> cc bore .010 over running a Judson Supercharger with boost about 6 PSI.
> The outside temperature is 87 F. After 5 runs the average was 30 HP.
> Is this good, bad?? Coments?
> PS: When I first started using this supercharger the maximum boost was
> about 4 PSI. Now that I am driving the supercharger with a smaller than
> stock pulley I am at the 6 PSI.
>
> Did anyone test a stock 948 cc with the G Tech meter? If I get time I could
change > out the supercharger for a stock set of carbs and run the test.
>
> In the meantime I am also fabricating an SU carb manifold for the
> supercharger. However, I will probably not have this conversion done until
> August.
|