Where should I start going through the components first? Master Cylinder,
or slave cylinder? Have tried all the spectrum of adjustment in between and
still the same thing. Back off the bleeder screw and it releases the
throwout arm. Hit the pedal one time, it engages it fully and then when you
let off it stays in place.
Leo
----- Original Message -----
From "Frank Clarici" <spritenut at exit109.com>
To: "LDS" <60bugeye@ev1.net>
Cc: <spridgets@autox.team.net>
Sent: Thursday, August 12, 2004 6:09 PM
Subject: Re: Cluth Bleeding
> LDS wrote:
>
> > It worked before I took it apart with this
> > pushrod so I will venture to say it is not the pushrod at the slave.
>
> Leo
>
> I bet you mixed up the master cylinder rods.
> Or you took them apart to clean and paint them.
> You have to adjust the clutch master rod, it is not letting the fluid
> thru the bleed back hole.
>
> --
> Frank Clarici
> Toms River, NJ
> JUST SPRITES
> http://www.exit109.com/~spritenut
Check out the new British Cars Forum:
http://www.team.net/the-local/tiki-view_forum.php?forumId=8
|