Hi Kendal.
Filling low spots depends on a few things. Are you sanding a primed fender
or a painted one?
Generally speaking if it's paint, and you do not plan on stripping it, I
would sand with 180 grit first to get good tooth for the primer. Any dents
or dings filled with a good filler like Evercoat then blocked with 180
again. A 2 inch dent 1/8 inch deep will require filling out at least an inch
from the dents edge. Mix in small batches on a real mixing board and use a
wide spreader. One pass over the dent, let it cure, fill again if still low.
Once it starts to harden stop! Buy a quart of acetone and clean your tools
and mixing board between batches to prevent dried filler from ruining your
work. When dents are filled, prime with epoxy if wanted, then a good
urethane surfacer, several coats, block with 320, fog a little spray can
black primer on it and the low spots will show up when sanded. Any small
waves at this point should be able to be taken out with just primer, if not
use a glazing putty which is smooth like toothpaste for slight surface
defects. For a real flat surface I will tint the next couple of coats of
primer with the car color then block again with 600, any waves will show up
easily. More blocking and priming with 600 will leave an extremely flat
surface ready for paint.
This is a very brief description of prepping for paint. You want to use good
urethane products all catalyzed filler, not lacquer. You will need a
supplied air respirator however as isocyanates are bad. There are some iso
free primers on the market which might be worth a try.
Good luck,
John
\----- Original Message -----
From "Kendel McCarley" <kmmccarley at earthlink.net>
To: <spridgets@autox.team.net>
Sent: Thursday, January 15, 2004 7:34 PM
Subject: Block Sanding... and Filling?
> I took a long block sander to the left fender of my '77 Midget this
afternoon. What I thought was a straight panel turned out to have slightly
high and slightly low places in it. Yeah, I can tap down the high spots,
but what goop should I use to fill in the low spots?
|