I'm stuck on a master cylinder rebuild, so I'm coming out of lurk mode to ask
for assistance.
It's a 68 Sprite with a dual line master brake cylinder. I was able to remove
the first snap ring and removed the plastic sleeve. My snap ring pliers can't
get a good grip on the snap ring down in the bore. Is there a special set of
pliers or some trick to removing it?
Thanks in advance!
John
/// unsubscribe/change address requests to majordomo@autox.team.net or try
/// http://www.team.net/mailman/listinfo
/// Archives at http://www.team.net/archive
|