spridgets
[Top] [All Lists]

Re: Seeking engine advice

To: spridgets@autox.team.net
Subject: Re: Seeking engine advice
Date: Mon, 28 Jul 2003 08:50:49 -0700 (PDT)
Eddie,
I agree with Gerard (New lifters with cam; I'd skip
the optional parts, but get the flywheel cleaned up at
least).  For the oil galleries, drill out the plug at
the back of the block and thread in a pipe plug, 1/4
NPT or 3/8, I forget.  For parts, buy what you can
from Peter C., then British Parts NW for the rest
(bpnorthwest.com, but call for inventory), they have a
ton of engine parts cheap, all good stuff (5+ years on
my Sprite without any problems, and I drive it like I
hate it). I used their D9 cam in the streetcar, $68,
similar to my SPVP4 on the racecar in performance
believe it or not; they have more streetable versions
as well.


> The minimum you need to do to the block is the
> following.
> 
> Machine work minimum:
> 
>   tank block/clean out oil gallery
>   Bore or .020 oversize
>   grind or polish crank
>   R&R cam bearing
>   R&R freeze plugs and oil gallery plugs
>   check deck and head for flatness.
>   check/correct line bore (main bearings) with what
> you described last 
> time, this  is important.
>   re-grind/check for straightness on cam, if you
> don't get a 266
>   re-surface or replace lifters
>   pin-fit pistons
>   Check flywheel friction surface and ring gear.
> 
> Optional:
> 
>   balance rotational mass.
>   lighten flywheel
> 
> Parts: Minimum
> 
>   new pistons and rings
>   new cam, main and rod bearings
>   new lower gasket set and head gasket
>   freeze plugs
>   oil gallery plugs
>   oil pump, depending on condition of your old one.
> From what you 
> describe of the engine, I suspect new will be in
> order.
>   Timing chain and gears.
>   Check your crank damper pulley. If the rubber is
> cracked, it needs replacing.
>   clutch kit?
>   new lifters if old ones are not resurfaced.


__________________________________
Yahoo! SiteBuilder - Free, easy-to-use web site design software
http://sitebuilder.yahoo.com

///  unsubscribe/change address requests to majordomo@autox.team.net  or try
///  http://www.team.net/mailman/listinfo
///  Archives at http://www.team.net/archive/spridgets


<Prev in Thread] Current Thread [Next in Thread>