--- "Robert E. Shlafer" <PilotRob@webtv.net> wrote:
> "upward" curve. This and the fact I've heard of no
> one else (thus
> far....your post to the contrary may bring them out
> of the
> woodwork, so to speak!:)
Selling the manifold would be bad on the knees, as
it's a loaner from Frank. An off line response was:
------------
Hi Ron,
Two things you can do. First you can file off the
plastic top of the
dampner, I do it at the same angle as the bonnet. Then
you have to cut
down
the motor mount on that side. I cut it in half and lap
the sides over
each
other and weld it back up. Between these two mods you
will get the
needed
room.
-----------
__________________________________
Yahoo! SiteBuilder - Free, easy-to-use web site design software
http://sitebuilder.yahoo.com
/// unsubscribe/change address requests to majordomo@autox.team.net or try
/// http://www.team.net/mailman/listinfo
/// Archives at http://www.team.net/archive/spridgets
|