Mike,
I could not find any data in the Bentley manual beyond, "installation
is the reverse... blah, blah, blah..." either.
I just happen to have a brand new, never installed replacement unit
that I dug out and checked for you. It reads from about 14 ohms to
somewhere between 240 and 250 ohms. Seems you are in range. This is
the type with the six screw holes as opposed to the locking ring
which is what you would have on a later car, but I think this is
still for the later type gas gauge though.
Gerard
At 9:48 PM -0400 7/26/03, Michel R. Gagne wrote:
>Good Evening (add in a great Hitchcock accent)!
>
>Before bolting in my new gas tank I unseized the float arm and checked the
>resistance of the unit. In the full position the resistance is 19 ohms,
>while in the empty position the resistance is 252 ohms. Is this within
>specs? I couldn9t find the information in either the Haynes or Leyland
>manuals.
>
>Does anybody have this data.
>
>TIA
>Mike Gagne
>Chapel Hill, NC
/// unsubscribe/change address requests to majordomo@autox.team.net or try
/// http://www.team.net/mailman/listinfo
/// Archives at http://www.team.net/archive/spridgets
|