Hi Jay,
To get it back to 100mm, you'll need this done on a milling machine to get
it accurate. Drilling will simply drift into the 4" pattern, which is about
a tad less than 102mm.
Later, Paul A
----- Original Message -----
From Jay Shaffer <shaf at zenten.com>
To: <midgetsprite@yahoogroups.com>; <spridgets@autox.team.net>
Sent: Wednesday, July 09, 2003 2:34 PM
Subject: bigger wheels
> I'm planning on evolving my Midget from ITC to Solo DP. So. I'd like to
> go to a 14X6" wheel. I will be changing the wheel studs to 7/16" rather
> than the stock (wimpy) 3/8' studs. How much offset would I use to drill
> the hubs and axles so I can use 4X100mm (Think Miata) wheels?
> TIA
> --
> Jay Shaffer
> ITC #66
> '76 Midget
> "This ain't no beauty contest"
/// unsubscribe/change address requests to majordomo@autox.team.net or try
/// http://www.team.net/mailman/listinfo
/// Archives at http://www.team.net/archive/spridgets
|