I have had the honour of looking at a pedal recently, and I believe that it
is not a solid bushing that goes straight through from end to end but rather
it is two bushings pushed in from the ends that leave a small ( 1/8th inch
??? ) gap between them.
Robert D.
( of course, it may not be original )
----- Original Message -----
> Daniel,
> Clarke's Spares in Pennsylvania offers the proper size bronze
bushings for the
> Sprite/Midget. Todd Clarke can be contacted at
clarkespares@worldnet.att.net. The
> bushes are slightly too short lengthwise, but it does not seem to be a
problem with
> the ones I installed. If I had it to do all over again, I would order
three, cut
> one in half, lengthwise and press the shorter half into the bore a ways
and trim
> off both ends, but it is not necessary.
> Mike MacLean-60 Sprite
>
> Daniel1312@aol.com wrote:
>
> > Hi list
> >
> > Does anyone have any of the little brass(?) bushes that go into the
clutch
> > and brake pedals? Or has anyone every had a batch made? I'm after a
couple so
> > I can be sure that the pedals are properly overhauled. Also, I guess
the
> > bushes were reamed after fitting or just opened out with emery paper or
just a
> > push fit.
> >
> > Thanks
> >
> > Daniel1312
/// unsubscribe/change address requests to majordomo@autox.team.net or try
/// http://www.team.net/mailman/listinfo
/// Archives at http://www.team.net/archive/spridgets
|